really nice car i am close to the same spot you are metal work done ready to paint floors and stuff on my cuda. what did you use for seam sealer, undercoating/floor paint? i am spinning in circles figuring out what i am going to do with mine. everyone says do it a different way haha. yours looks...
i put my transmission in to test fit my v-gate in the floor. put the mount in and shifter on but then the driveshaft is a few inches too long. the driveshaft and transmission are out of a 67. the car is a 68. i used the automatic transmission cross member. are they offset different? do they...
got the floor pans done...does anyone have the size of a mr. gasket v-gate boot? I am going to order one but I want to get my hole roughed out. For now onto welding the trunk pans, extensions, and new quarters in......fun fun
i can use a stock transmission hump with my v-gate shifter? just cant use a console correct? if not what is a possibility for my v-gate? fab my own tunnel? thanks guys
hey guys im looking for probably someone with a parts car to cut probably 8 inches where the roof meets the quarter so i can weld it in. its going to be a pain in the *** making that joint with the two window trims there and everything. let me know i can send a picture of what i need. thanks!
hey guys i am wondering if anyone knows a good way of removing the lead joint where the roof meets the quarters on the barracuda fastbacks. i have to weld new metal in mine as its rusted out. thanks guys
hey guys got my rear floor pans installed today now onto the trunk/quarter area. . the new floor pan for the trunk should go no problem after the spot weld fun. the quarters i am wondering where to run the new quarter to. the bottom, front and back is all spot welds but where to connect the...
Finally getting around to start a thread with my restoration. Have not been doing much the past month with christmas and being in brazil for work (not all that bad :) ). So far I have the interior pretty much gutted, the engine and transmission out, and just received the floor pans and quarters...
and the worse part of all...i go in circles with what I want to do! everyone has their own way I guess haha. I think I am just going to get the floors all welded in. Sand down the floors from firewall to trunk with some 80 grit sandpaper and the ole orbital sander. then ill brush on the por15...