Recent content by cybrtygr32

Mine is riveted to the driver's fender right about the battery on my 67 Ratfish Fastback.

Thanks Woody for all you did for me on the stainless trim! You a man of your word!

Mike Parting out a rough 69 fast back, it has a fairly nice pair of "green" visors". Would that help? Or PM me.

you still have the moldings mike?

Here is mine, no vert, but hey, it's an A.

Tried to upload another photo, not sure it worked. computer troubles!

Thx Mike. My name is Mike as well and the car has been given to my oldest daughter. (I'm doing the work though!). This fish was bought new in Jacksonville Fl. I know what I'm about to say will get me kicked off the board, but I ditched the 7 1/4 rear and dropped in an 8" Granada rear. It has...

I found this sick fish in a barn about 7 years ago. I pulled it out with a tractor and a chain. It shows 79,500 on the odometer. It still had the certicard under hood where bought new. 273 engine / 904. I have since put in new trunk pan and rear lower quarter patch panels. New shocks, gas tank...

Thanks txstang84 and Ted. Didn't know about the converter size. I will inform my 904 builder to get me a 318 torque converter. As far as the induction choice, I really would like to use my 273, remaned 2 barrel and my exhuast manifolds if possible, for now. I also think I will use the 273 water...

Thanks for all the help guys. I got the engine home and on the stand. It is rebuilt, 30 over, valve job, new water pump and fuel pump 318 (talked to the engine builder),,,BUT I discovered something else. It is not a 1971 318, but a 1978 318 after checking numbers and pulling the vavle covers...

Thanks for info. The 318 engine already has a new water pump and fuel pump bolted on. I was planning on getting a new aluminum radiator as mine is toast. So I can just bolt on my 273 exhaust manifolds and cast iron 2 barrel intake? That is good news! Are you saying I need to use the cast iron...

Hey guys, help this old guy out. I have a nice rebuilt, 30 over, 318. It is just a long block. My 67 Cuda has a 273 2 barrel engine. Will all my brackets for power steering and alternator, starter, etc. fit the 1971 318 engine and are the engine mounts the same? Since I'm asking questions, what...

Thanks Dart, but what is the way to assemble the two piece metal retainers? The longer flat piece, I can see how it goes on, but the smaller piece, does it go on top or where/ thanks for your reply. Also, I have run into another problem on my conversion. Barracuda (67) outer tie rods, big bucks...

How do the retainers go on to hold the calipers on? And, what are those rubber bands for in the kit? Thanks guys, all this stuff was apart when i obtained the swap items. Any pics would be appreciated. (swapping out drums to disc on 67 Barracuda, using 73 Duster disc.)

Okay guys, I hate to ask a question on here that has been beat to death, but I searched and couldn't find what I needed (on brake pedal push rod), so here it is: Going to install a 73 Duster Power Master Cylinder (no booster) with 15/16 bore on my 1967 Barracuda Fastback. Will the existing...