yes the ignition switch is new but havnt replaced the ballast. my ecu is only 6mo old i think. i did drop a distributor in that i had laying on the shelf. would that have anything to do with it?
i have a 76 plymouth 360 duster with electronic ignition that when i turn the key it wont start till i release it from the crank position. it acts like its not getting power while cranking but i have replaced everything in the column. any ideas??
i know this is an old post but im gona go ahead and update it...i found out i had a driveshaft for an 8 3/4 so i bought a conversion u joint till i find a 8 1/4 drive shaft
lol my wife and i take our daughters to pre-k every morning and all the other parents are in pj heaven (alarm clocks should be set 30 min earlier...jus sayin )
I thought about using a conversion joint but didnt know if there was one out there that would work for me. I will see if i can find one online (Our local parts stores suck when it comes to looking up parts)
I have a 76 duster that has been sittin around a couple of years. well i finaly got to working on it and tried to install the drive shaft that came with the car (the kid said it was from the car, but the car was a basket case when i bought it) the rear ujoints were too big so i ran the numbers...