Recent content by KCS

My 71 Swinger runs great but every 5 to 600 miles I am having to add at least a quart of oil. There is no smoke and just a tiny trace of a leak. The motor was built in March. Here are some of the specs: 1968, 318 block, Wisco pistons at 0 deck, Scatt connecting rods, Ported and polished 360...

Does anyone have suggestions for brand names and sources for steering box seal kits? Also, it's my first time doing this procedure so I would appreciate any advice and/or directions for doing the job. I am a novice so step by step directions are welcome!

I'm looking to turn my 67' 318 short block into something a bit nastier by bolting on a set of 340 X heads. They don't need to be finished, just in rebuild able condition. Thanks folks!

I am selling a classic1979 Ford Ranger pickup truck in very good condition with just 78,000 miles for 5500.00 or B.O. It has been stored during winters and served as my daily driver during summers. The 6 cylinder engine supplies good power and torque and the manual 3 speed transmission on the...

8 3/4, 4 " bolt pattern rear end for 71' Dart Swinger. Prefer 323 or 355 gears. Posi not mandatory but nice option.

Thank you very much for your quick response and information!

I am looking for two small bolt pattern (4") rallye wheel bullet center caps to finish off my 71 Swinger. Please include descriptive photos. Thanks.

Does anyone know the stall rating of a stock 1971 318 Dart Swinger torque converter with a 904 automatic transmission and 7 1/4 rear end? Some one said that it is good practice to choose an after market converter that "locks in" at 500 RPMs higher than the initial rating of the cam. My Mopar...

I have recently installed a purple camshaft with 268/272 duration and .450 lift as well as an Edelbrock 1406 carb, duel exhaust, and electronic ignition. The car is an original 318 automatic with factory gears and 7 1/4 rear end. I have been considering replacing the torque convertor to give it...

I removed the AC compressor from my 1971 318 Swinger and I am looking for a replacement water pump pulley to accommodate the change in belt routing. I just replaced the water pump with a genuine Mopar unit. I am having trouble finding a true Dart pulley. Does anybody have any ideas about where I...

I am looking to buy an Edelbrock LD4B intake for my 71' 318 Dart. It must be in very good condition and ready to install.

I was informed by a member of our Mopar club that there used to be 4 barrel intake manifold designed specifically for the 318. Everything I am seeing online is designed for 273, 318, 340, and 360 motors. I would like to track down a 318 specific model that will best fit the smaller 318 runners...

I have been getting all kinds of helpful recommendations for my 71 Dart. I am also looking to install a dual exhaust system and use the stock manifolds. There is a guy near me who fabricates exhausts and he is asking me to choose my own mufflers. What are the best mufflers for throaty sound. I...

Thank you everyone who submitted ideas for waking up my stock 381 Dart! Changing out the cam was suggested by a few folks. What type of cam would be enough to maximize the potential of my motor without sacrificing a comfortable idle. I do not plan on racing the car but I want to feel confident...

I just bought a great looking, smooth running original 1971 Dart Swinger at Carlisle. I am looking to hot rod it a bit. What intake/4 barrel carb combination is recommended? Any other suggestions for improved performance would also be welcomed. Thanks.