Recent content by matsucu06

Okay, thanks! Guess I'll run if for now until there's a reason to change it...

Thanks guys! Didn't even think to check the ratio before I installed. Would have to pull DS header to pull the steering box out... Seems to work okay aside from the limited turning radius... Any other downsides to this lower ratio?

Hey Guys, I'm sure this has been covered before, but was wondering if there's a typical number of rotations that a manual steering box should turn? I was working on centering the number of turns per side (Left vs. Right). The manual steering box only has a total of 4 1/2 total turns of the...

Very nice! Haven't been out to Sonoma for a couple years now... Do they still have open amateur nights on Wednesdays and is it 1/2 or 1/8 mile? Used to go after work on Wednesdays during the summer to see what showed up. Would see a lot of "Fast" (10 sec) imports... Not a "Hater" by any...

Okay, thanks. I think I'll try a snap ring pliers first and go from there...

Hey Guys, Need some help on how to remove the ignition switch from a 68 Barracuda. Assuming it's the same for a Dart... Looking to remove the entire switch unit to swap the "Key" assembly. Ignition and doors were keyed different when I bought the car, so I purchased a matching ignition and...

PM sent

Okay, thanks. PM sent to convdart440 to make contact...

Sorry for the delay. Engine is still for sale...

So very sorry for your loss... Please take some comfort in knowing that our thoughts and prayers are with you in this most difficult time. Treasure the fond memories of your son and cherish the time you've had.... Most sincere condolences from another father that knows the pain of losing a...

Prayers sent for Sadie Mae. Hoping for a speedy recovery! Hang in there...

As of now, still available. This little motor ran well before I pulled it and replaced it with a 340. So, would be worth the drive. I still have my engine hoist set up and would be easy to lift off the engine stand and into a truck. Just let me know... PM me with any questions...

Ok... Several folks interested, but no follow-up.. So, let's try this... Neglected to include photos of the "Custom" painted oil pan, included with the motor... After seeing this, there has to be some local folks in the Bay Area that are interested! Probably looks even better with a good...

It's amazing how sometimes desperation can drive creativity!

Conclusion / Summary Seated the power connection in the bulkhead connection to ignition and can now crank/fire the motor from the ignition switch Finished the cam break-in @ about 30 minutes @ 2500+ rpm Verified new Melling Oil Pump was HV and not HP (pressure) After installing the two screw-in...