Recent content by Nokke

I have a griffin 3 inch original style alu radiator works perfect never runs hot and it looks the same as original

hey guys i am very happy 629,0 hp at 7100 rpm and 506,1 ft / lbs 5700 rpm im going to scan the dyno paper and show you guys and show you a video from the dyno

yes thats right engine dyno i have a hope on a 6 something but you newer now

Hey guys im going to the dyno on saturday any guestimates on hp? 1984 360block hughes main girdle, windage tray Eagle 4340 4.000 inches crank Eagle h-profile 6,125 rods Srp pistons compression 11,48 indy cylinder heads 210cc ported & polished flow intake 308 cfm exhaust 232 cfm comp...

Hello all of you i have this question. It can sound like a pretty dumb question but when you say that the lifters uncovers the gallery do you mean that the skirt on the lifter is passing the oil hole in the gallery so the oil can leak downwards out of the hole with the result of loss in...

Anyone?

hello guys does any one of you no if the comp cams endurex lifters has oil hole lower down or if theres any another lifter that has it. Because i need a lifter with the oil hole lower then 1,45 inches i have measured from the bottom of the wheel to the oil hole on the lifters. The problem is...

yes thats correct what do you think is the cam too small?

thanks for all the answers. 7172 duster your engine seems strong the power looks to raise fast on the top end must be a real kick. i have ordered a comp cams rx302s-r6 with valve lift 654/655 and 269/276 0,50 duration 106 lobe center but i have 1,6 rockers so the lift is going to be 697/698 i...

yes i have a flow sheet on the heads im going to bring home tomorow its out in the garage then i am going to write the numbers down. the fuel is regular shell v-power 99 octane its a gas you can buy on every gas station in sweden from pump

Hello guys i have looked at comp cams rx296 solid roller 649/654 0,50 263/270 duration that with 11,5 in compression is that conserative

they guy that ported didnt grind the chamber very much i have measured today again the piston and it gave 21cc thats the hole cylinder with the piston in tdc i measued i have looked on a comp solid roller rx302 is that a good cam? Thanks for the answers

the heads has been tested they flow 307 on 650 lift that guy that flowed them has all the numbers so i can them if want and show you? yes i use and adapter to the 1050. the piston is dished and i have filled it with liqiud and the result was 26cc and the heads cc was 62 the rockers are td...

yeah im going to talk with brian thanks. no im not rich but all my money goes on the car :-)

im sorry but i dont wont forced induction or nos i wont an naturally aspirated engine but i now its very good things to get power with