Any ideas on cheaper glass?
Also are the parts for the wipers available anywere? I bent the one driver side one since the wiper arm was seized to it and I'm sure the passenger side that snapped the arm isn't much better.
Ended up pulling the cracked windshield from the dart today since it was finally nice out again. I think either the windshield itself was/is leaking and/or the wiper pivots.
Any suggestions on where to get a new gasket and glass? So far nobody local has anything and if I remember...
Finally got the rear brakes torn apart and the driver rear is definitely leaking.
I took some picture before I went to work but I forget where i put the camera at the moment.
How hard is it to replace this seal? I did some research and is looks like i should be able to just pop out the...
Since I'm in the middle of redoing my entire brake system I got to talking with a guy at work about pressing out the hubs from the old drums and into the new drums and he suggested probably could get new hubs for not too much money and just get new parts pressed in and have it be easier overall...
Well the funny thing is every parts store i called including napa all say the same thing.
Must be pulling incorrect info from the same source or maybe it specs 2 for 4 wheel disc brakes perhaps.
Making some progress getting stuff tore apart to get final needed parts and start on replacing things.
Parts store swears that I should have 2 rear hoses and I only see 1.
Is there a second hose I'm missing?
Got all my jackstands tied up in the front atm so i can't jack the rear for a better...
Everything is on hold till thursday or friday for the moment. Weather is kinda wet at the moment and work eats up a large part of the day.
I may even do a complete article on how to completely redo the entire brake system (from a n00b perspective) and get pictures of everything.
Is this the pump wire for the electric pump? Nothing else around it seems unplugged and it reaches about the hole where the tank/pump should be bolted down.
I'm gonna take a stab it at later this week if the weather permits.
Probably gonna grab a 25' roll of Nickel Copper lines from the parts store for $50.
Never will I have to worry about rust again!
UPDATE.
Well I got all the parts in yesterday and after cleaning up some other things I started on the brakes.
Apparently I'm gonna have to replace everything up and probably including the Master cylinder cause it a tad crusty too.
Started on passenger front wheel and it started off...
Thanks I'll have to check it probably is foot pump being a base model car. Where should this foot pump be? If that's missing I'll probably add the option for a wired pump.
Where would be the best place to find factory mirrors?
That was my attempt to contain some of the garbage the...
I can cleaning up some of the grime the other day and noticed the wiper spray nozzle sticking up and noticed the hose going over to this.
No wiper reservoir! Before it started downpouring I tried to see if i could find wires for a pump or anything but didnt notice anything obvious.
Any...
Thanks for the advice and it makes sense the more I think about it.
Ordered the drums, wheel cylinders, shoes and a few other small things that the car needs last night.
Talked to a few guys at work about what I was thinking and they dont like the idea of cutting a 8.8 at all unless a shop was...
Well after a bunch of research last night I'm thinking about getting a 8.8 rear out of an explorer having it one side trimmed to even it out and having it refreshed to maybe a 3.27 L
I can get a open rearend assembly for $100 nearby. The fun part will be finding a decent shop to do the work to...