Recent content by piperdrums

  1. P

    Want to change my 2bbl Stomberg Carb to a 4bbl set up.

    Thanks everyone. It sounds like a 318 intake will work just fine.
  2. P

    Want to change my 2bbl Stomberg Carb to a 4bbl set up.

    Hello, I have a 65 Barracuda 273 V8 with a 2bbl carb and want to change over to a 4bbl setup. I'v tried looking for an original 4bbl setup for the same year barracuda, to much no luck. Can anyone help me with the parts I will need to convert this to a 4bbl carb and intake new. thanks.
  3. P

    Need a 4bbl Intake for my 66 barracuda 273 2bbl

    Thanks everyone. Cameron
  4. P

    [FOR SALE] 1965 273 factory 4BBL intake and 318/360 Edelbrock tunnel ram

    Hello, I want to make sure this manifold will work on my 66 273 V8 Barracuda. I am converting my 2bbl to a 4bbl and this looks like it might work, can you confirm. I can offer you $100. plus pay for shipping. Thanks, Cameron
  5. P

    Need a 4bbl Intake for my 66 barracuda 273 2bbl

    Is there a tread on the forum that show all the parts I'll need if I go with a Edelbrock intake and Edelbrock 4bbl Carb? Thanks
  6. P

    Need a 4bbl Intake for my 66 barracuda 273 2bbl

    Thanks guys! How do I find Mike on the tread who had a stock 4bbl intake for sale?
  7. P

    Need a 4bbl Intake for my 66 barracuda 273 2bbl

    Does anyone know where I can purchase a 4bbl intake manifold for my 66 barracuda 273 with a 2bbl. I want upgrade to a 4bbl carburetor but want to get the right set up. Thanks for your help.
  8. P

    Brake Master Cylinder 65 Barracuda

    I need some help. I have a 65 Barracuda V8 273 with front dist rear drum manual brakes. I cant find the right master cylinder. Is this off a 72 duster? or a 72 Dart? and does anyone stock this or is it a special order only. Thanks.
  9. P

    Runs bad when hot.

    Thanks for the advise. I'll try the thicker base gasket first.
  10. P

    Runs bad when hot.

    I tried that no go. what is the solutions? Thanks
  11. P

    Runs bad when hot.

    I installed a rebuilt carter 2bbl on my 65 Cuda 273 V8. it runs fine when I take it for a short drive. When I turn it off it starts up but when I put it in gear it wants to stall unless I really rev the engine and keep it going. Is this a vapor lock issue? only happens when the care is warmed...
  12. P

    Finally have fuel from pump. Won't start after I turn off

    I have a stock 2bbl bendix Stromberg. I do appreciate all the advise.
  13. P

    Finally have fuel from pump. Won't start after I turn off

    there is fuel leaking from one of the screws under the carb bowl, but it is not leaking enough to drain the bowl completely. Are the two screws the jets?
  14. P

    Finally have fuel from pump. Won't start after I turn off

    I bought this 2bbl bendix Stromberg on ebay and it seemed to run ok. Is there another brand of carburetor I can use instead of this carb? Carter? just asking.
Back
Top