Recent content by Twisted72

Try RacingJunk.Great site.

Hey Dartman,I put a remanned 360 in my Duster to start with,got it from NAPA auto part's,used it 3 yr's with no issue's,drove it everywhere.About $1400.00 if I remember right,came with a warranty too.

Hi,I have one coming from another member,so hold onto your's incase you need it,thank's for the reply.

Hi,I need the threaded interior bezel that hold's the remote mirror control to the door for a 72 Duster sport mirror,the Devil must be sitting on mine,need it to finish my interior,Thank's

Hi,before you go any further you should use a grommet where the wire's pass through sheet metal,don't take much to rub through and cause a meltdown.Good Luck

I painted mine inside with white paint,work's great,taillight's too.

A lot of liability.

If this help's anybody,I've seen the car at a local cruise-in last month,talked to the owner,not a lot of Duster's around here.It's real clean for it's age,and I see him driving it a lot.If I was looking for another one I'd buy it.

Good luck with the hunt,I haven't found one yet.

Hi,I need a Plymouth emblem for the driver's side front of hood for 72 duster,approximately 5 1/2 x 3/8 with 3 pin's,got a nice one?how much to 48706

I painted mine,get lot's of attention and compliment's.Not hard to do.

They actually blew up Project X racing the Cobra,when they show it going away and you see a big puff of smoke.

Hi guy's,I just picked up a nice 187 oilpan for my 383 in a Duster project.I need to get a oil pan pick-up tube for it,my engine is a 66 Dodge 383.Any help is appreciated,Thank's in advance.

Try rapping with BFH first,then try prying off.Sometimes heating drum around axle with torch help's,all else fail's,relieve adjuster's.Hope this help's.When installing drum's apply a little anti-seize around axle where drum makes contact.

Congratulation"s