Search results for query: *

It's time for me to give up my project car. It is a 1964 Plymouth Valiant Barracuda. I am the second owner and it has been in the family since new. I know the full history of the car and have a lot of documents to show. I have the original bill of sale and all plates that have been on the car...

It's time for me to give up my project car. It is a 1964 Plymouth Valiant Barracuda. I am the second owner and it has been in the family since new. I know the full history of the car and have a lot of documents to show. I have the original bill of sale and all plates that have been on the car...

It's been a while since I've been on the forums. Haven't had much time in the last few years. So here is what I got.... It's time for me to give up my project car. I need a little help in estimating it's value. It is a 1964 Plymouth Valiant Barracuda. I am the second owner and it has been in...

Just curious, how have you guys replaced the pitman and worm gear seals on the manual stearing box? Do you use the special tools? I'm not wanting to tear the whole gear box apart right now. Mark

Looking for a new pitman arm grease boot or seal. Also looking for the seal that goes on the bottom of the steering column. Not sure what it's called. Manual calls it two things: Column lower seal and jacket seal. Pretty much the seal at the bottom of the tube that the steering shaft comes out...

I have a fresh 360 that I'm getting ready to install. I was priming the engine and decided to check and see what the oil pressure was doing. I put a cordless drill on the priming drive shaft and put a gauge on the oil pressure port. The gauge went straight to 85 psi. Is this normal for a newly...

I'm going manual brakes in my '64 Barracuda. I have disk/drum setup from a 72 Dart and stock booster right now. Do I go with a stock '72 Dart manual mc? Will all a-body manual pushrods work? Does anybody have one to spare? Or an aftermarket that will work? Thanks Mark

Will a '66 Barracuda manual steering fit my '64 Barracuda? I keep seeing comments like "'66 and up". Why don't they say older cars? Both are from V8's Thanks Mark

I have a 360 in my '64 Barracuda. I've put the MP cast valve covers on and the brake booster hits them. I know I can put the stamped covers on but would like to run with the cast. How can I fix this? I've heard that there is an offset booster. Is there one and what years am I to look for...

I have a 1964 Barracuda that I'm putting a 360 into. The stock radiator is the 19" core. Right now with the 360 in place and using the alum. water pump housing, I have 2.25" from fan to radiator mount. I'm am using the stock fan and spacer (which I think is 2"). I need help on finding a...

I'm dropping in a 360 with M1 dual plane and Holley Street Avenger into my '64 Barracuda. All of the linkage and throttle cable are stock. What do I need to hook all this up? Photos would help. Thanks Mark

I need to replace both front and rear window gaskets. Where can I find some quality gaskets without paying a fortune?

I have a 1964 Barracuda that I'm putting a 360 into. I have the original Federal pump off of the 273. The bracket that I have will not fit the '70 and up alum. water pump. Are there any brackets that do fit the alum water pump and the federal pump? I have a Saginaw pump and brackets for the 360...

I've got a '64 Barracuda that I'm putting a 360 with a 727 into. The car is a 904 pushbutton auto. The 727 that I have is a '64 pushbutton also. The first thing that I noticed is the transmission mount location is about 1.5" forward of the 904's. How do I solve this problem?