Search results for query: *

A friend saw this car in Delaware , and sent me this picture , sorry he didn't send a picture of the whole car. Anyone have any details of a 440 Dart ? I never knew they did it.

Hi Guys , So if I tighten the nut down , and I can still spin the hub , where should I start to trouble shoot this ? 65 with 9 inch drums

pulled out the old dizzy from my 1965 225 slant , to put in NOS Chrysler electronic dizzy. For the record , I never did this before. So I have a few questions. Do I put The big washer / seal from the old one on the nos ? And should the NOS dizzy have a seal on the shaft? NOS old

Looking for a distributor wrench for /6

I am thinking about going front discs on my 65 valiant , front drums are worn out , probable out of round ,Don't think they can be cut anymore, looking at kits for sale , but don't know if the spindle's are worn also. Any advise would be great.

got one Thanks Anyone know where I can get this part - holley 1920 carb

Everything on the engine looks clean , but the gunk on the valve cover can't be good . Doesn't smell like gas , has the look of baby food , a little watery. like steam was mixing with the oil spray on the valve cover? oil on the dip stick looks good , any thoughts?

Hi Guys , after rebuilding 2 holley 1920's I can't get the idle lower then 1000 or so ,She starts right up on warm days ( no chokes ) and is running stronger then before the rebuilds. I have backed out the curb idle screws till they are not touching the carb at all , and it won't go lower then...

Hi everyone ,Have been having a little stumble starting out in 1st gear, almost stalled every time. I have only put 300 miles on it since I got it. So I finally toke apart the first of the 2 holleys , never did it before , I kept putting it off. I was very careful , and started with the carb...

I don't know much about this subject , so any advise is Great ! after a 20 mile drive yesterday I see a puddle under the trans - 1965 valiant 4 speed - Trying to determine where it was coming from I put it on stands , dried everything off , and ran it till it warmed up , then get back under...

I replaced everything on both axles last winter , had the front drums turned , the brakes seem to be working fine , after 20 -30 miles of stop and go driving a clicking started in right front wheel. Pulled the drum and found that the self adjusting cable had slipped behind the cable guide , and...

Here is the build sheet that was in my valiant , I figured out most of it , some codes I don't know , anyone collecting info take a copy any questions just ask:coffee2:

Is it OK to take power off the terminal on the ballast resister to fun an electric fuel pump? I tried reading up on what the resister is for, and it sounds like the voltage changes? To me I think it is not a good idea. 65 slant 225 valiant

I'm having trouble with the linkage from my gas pedal to my offy manifold. Previous owners swapped to the offy with 2 holly 1920, and the peddle is why to stiff. Looks like the rod going through the firewall is not sitting correctly. I think the bushing it goes through my be shot,and the rod...

Trying to find a shop to resurface my 9 inch front drums , no luck so far , any ideas out there. I'm near philly and Delaware. looked to buy new ones , classic only sells the bare drums ?

I just purchased a 65 valiant 200 , 225 4 speed , I need to replace bake brakes , looking at the springs on the car , they don't match the springs in the kits for sale. the springs holding the shoes on are the 69 version with the cups on them , I was wandering if I should but them back to the...