Search results for query: *

I installed a Tremec TKX in my 73 swinger. Bought the kit to go from auto to manual. They included a clutch/ brake pedal assembly. I also bought a wilwood 15/16 bore tandem master cylinder and installed it. I've tried every combination of master cylinder pushrod length and ends(clevis & eyelet)...

Hey everybody. Swapping my 904 auto over to a tremec tkx and am wanting to install bucket seats. I'm looking at the Procar classic 1500 series. My dart is a bench seat car. Was wondering what mounting brackets to use? They sell an abody specific bracket but I assume it's bucket to bucket swap...

Quick question for a new six pack owner. Does the throttle return spring bracket use an intake bolt to mount? Thanks

I have a set of new Holley six pack carbs with the promax metering plates installed in the outboards. Ran the carbs about a year ago with a mechanical fuel pump everything was fine except the 2 middle cylinders on both sides read 300 degrees hotter than the outer cylinders. No matter what...

I have a 408 stroker with an Indy mod man intake with the 3x2 carb plate on it. Bored .30 over with scat forged crank and Keith black flat top pistons. Mopar purple cam with .508/.508 lift. Edelbrock rpm performer heads with Hughes engines bigmouth porting. Center carb has 68 jets outboard...

Just finishing up a 408 build for my 73 Swinger. Was wondering if there is an engine dyno around Ft. Wayne, IN? I've found a chassis dyno place Greer Performance in Ft. Wayne but the website isn't very good. Just looking to dyno the motor so I can justify all the money I've spent lol. Any advice...

A few pics of my first engine build.

Building my first 408 stroker and went to grab oil pump bolts to install pump and they were missing. Somehow they got thrown into misc engine bolt drawer. Looked every where for a pic of them can't find one on the net, and I can't remember what they look like. If someone could post a pic of a...

For sale is a mild street 360 motor. Comes complete from oil pan to air cleaner. Also included is a set of summit ceramic coated a body headers. Carb is a Holley 750 cfm. I do not know cam specs. Motor is still in car so you can hear run and go for a test ride. Asking $2800 for everything. Pm...

Building a stroker this winter for my 73 Swinger to replace the mild 360 that's in it. Looking at a Hughes 426 stroker kit with forged crank and billet h- beam rods or a Scat kit with forged crank and forged i- beam rods. What would you guys suggest? Only waiting on rotating assembly to complete...

Looking for an aluminum small block six pack intake. Please PM if you have one.

Getting ready to put a new sure grip in my 8 3/4 and buddy trying to talk me into using a crush sleeve eliminator. What are the pros and cons of using this over the crush sleeve?

A buddy of mine and I built a 904 tranny for my dart. It will manual shift thru the gears fine but when put in drive it goes into third gear and stays in third. It won't even downshift out of it. Have tried two valve bodies in it and does the same thing. Anyone have any ideas what it could be...

Anybody on here ever use a right SS spring on the left side? I need some clearance for my tires and gonna put SS springs on this winter. I don't mind the slanted stance with SS springs but would rather have even rear if I could.

HI everybody. My name is Brandon. My brother in-law (pyschomoto) turned me onto the site. Said I had to get pics up on here, so I'm gonna try. Picked up my first a-body today. It's a 1973 Dart Swinger. Has a 360 with a 904 and an 8 3/4 with 3:91's in it.