Search results for query: *

7.80's 1/8 mile nothing to fast

Nice

That's a hell of a lot of travel from UCA to bump stop does car react good lights? stop

Wouldn't that create alot of travel in suspension?

That would be lowering the tosion bar adjuster right? When lowering do you have to loosen the pivot shaft nut or is that only when raising

I posted this in the racers forum but looking I probaly should post it here I'm kinda new to all this forum stuff I need some help tuning the front suspension optimal on a slow bracket car to I'll give you a run down what has I will post some pictures also. - 67 barracuda w/ stock 440 out...

So everyone I need some help tuning the front suspension optimal on a slow bracket car to I'll give you a run down what has I will post some pictures also. - 67 barracuda w/ stock 440 out of 69 charger nothing fancy done to engine - low gear for drag racing - Stock but rebuilt front...

Just how tight you tighen this front nut hard to get a torque wrench in area

This is suppose to be a one piece I believe it's a bushing from later model won't tighten up

Yes I realize my mistake it should be a one piece is there is anything I could rig up to be able to tighten this up torque specs. It's an old track only bracket car doesn't see the road. I really dont want to pull torsion bar and LCA yet again

Strut rod question : 67 Barracuda I just learned I have the rod that uses the one piece bushing no sleeve I mistaken put on the two piece. any mopar guy got any secrets of get this to tighten up without just squishing the rubber out. Just pulled front bushing rear is in and intact. I really do...

Halifaxhops informed me that this distributor doesn't trigger separate it keep point open longer for more dwell. Not individual. Look at the cam lobe both sets kinda just overlap each other.

No the cable frayed had to take it out

I had msd box. I like advance on distributor. Car is strictly bracket drag racing car. Save money.

So I recieved some help on getting replacement points I am very thankful. Next question would be given I'm triggering a msd box with this distributor (which MSD say remove the trailing set of points) is that possible with this distributor or does it require both sets of points to run. If...

One other question i currently have this distributor running through a msd 6al box with white wire Does this need both sets of points to run on this distributor I always heard taking out the trailing set of points if so which set is the trailing set. Also if triggering through msd do I still...

Im sorry sir I'm not sure what you mean now or nors. how much would you want for a set

Understood

Would I be wasting my time putting a pertronix ignitor in this distributor considering it's older unit or are they pretty tough units

Thank you. One other question whats the best budget friendly decent quality distributor to do this any tips or advice would be much appreciated ¹.

Appreciate its time to take it electronic

IBB-401A number

Sorry will this help

68 barracuda w 440hp out of 69 charger

Help IBB-401A dist Two questions 1. Where can I get another set of points? I've browsed nearly everywhere no identical set. 2. Do point have to look exact same or as long as they bolt up . Same question but condenser.

Help IBB-401A dist Two questions 1. Where can I get another set of points? I've browsed nearly everywhere no identical set. 2. Do point have to look exact same or as long as they bolt up . Same question but condenser.