Search results for query: *

It's an elevator. :lol:

And being a dumb target means a short life lol

That is definitely a good deal considering about $ 2800.00 of mine is just the intake and carbs that's not even counting what it would have cost to weld , port the tunnel ram & resurface all machined areas

Well now you have a spare set to put safely away inside your shop

Probably not much but there's a lot of torque in that heavy flywheel.

feeling dumb is better than feeling like a target.

Good they were there. False alarm!

$20!!

Well…. To those who haven’t already figured it out. I am an idiot. Buddy showed up with ramps to borrow. He crouches down and says…they are in there, just slid way back. He had borrowed the trailer from me a while back to pick up a car out of state. He could bend over far enough to see them. I...

:realcrazy: :eek:

Thank you, crazy to me that they put those adjustments in there, but I guess it’s a good thing in the end!

Captured FW190?

I have you for an LG , correct?

1: battery operated hand grinder with a thin wheel cuts thru a lot. Sorry to tell you only locks keep honest people - honest. 2) crack heads do more damage then I care to mention. May had been just a thief but I see lots of complaints of stolen stuff the last 3.5years. Make drugs legal they say…...

This is a Set of 12 Big Block Valve Cover Bolts. They are in good condition, just need a cleanup. $30.00. Local pickup, or buyer pays shipping.

Not mine bit I found someone selling a fresh build with dyno video on facebook market place. It made 600 Hp at 6,000 rpm on 91 pump gas. They are wanting 10,000 for it. Is that a good deal or not?

Bump $180 plus the ride.

Or go here: And/or here:

Woke up this morning to the furnace running :wtf: Thermostat set at it's lowest point :lol: I think that prompted me to check out Mammoth Mtn's Ski Conditions. I did ski Mammoth on Memorial Day Weekend, many years ago. Yup! They still open. About 1/3 of the runs and lifts still open. A little...

If you're going to MITP, I'll start-up Bazza's 318 for you, 'cuz if you wanna here that Mopar starter whine, it's got plenty to spare!

I couldn't stay-up to watch the O/T, but sure am glad the Oilers won!

We used to have tube and fin style trans coolers and had the same issue. Since have switched to plate style coolers (ours has no fan) and we don't have an issue with them getting hot anymore. I actually installed a thermostat in mine to help the trans warm up quicker. Ours are mounted in front...

I hear ya, a head that flowed 260 cfm ootb, and the porting potential into the 300 would be a one stop shop head for both the street and the strip. Besides the price, I remember not wanting to deal with the rocker shaft blocks when they came out. Of course there wasn't a FABO around back then...

Long bolt cutters are a thief's best friend. Especially when they can use ground level as leverage.

“…….it puts a smile on my face just knowing that I was a part of that generation that got to experience every thing Detroit had to offer and now, I get to live it one more time……..” Age wise we’re probably within a few years of each other and I know exactly what you mean. I started out working...

I'd suggest super stock springs and a stock K frame since it's a "budget" build. If you were are planning on getting in the mid 500+ HP range I'd suggest cal-tracs. After market k frame stuff is nice, but pricey too. As long as you can find stock stuff cheap I'd go that route, if you can't...