Search results for query: *

What is the best place to get 3:55 gears for a 8 1/4 rearend ? I have 3:23 now and would like to move up. And also would that help me much for quicker response. Thanks

I am wanting to find a 3.73 or equivelent for my 8.25 axle on 72 duster, which was donated from a 73 duster. I am only able to find 3.55 or 3.90's. Any thoughts on where to find them at? Also do ALL chrysler 8.25 ring & pinion swap out with each other or is there a certain carrier like a 8.75...

I need a basic rebuild kit for my a body 727 (72 or 73 model year) pk 3681053 4083 1473 what do you guys recomend? Its a car show city cruiser with around 340hp. I am considering this one? http://www.summitracing.com/parts/TCI-128700/ another member gave me...

Trying to figure out if my trans is a lockup trans or not. The numbers of the rail are PK 3681053 4083 1473. Person rebuilding my trans said I need to find a 727 from a big block as a donor to use some of the internals to rebuild mine if its indeed a lockup trans. Its behind a 350hp 340...

wanting to know what chrysler vehicles commonly have sure-grips in them that would be at junk-yards and gear ratio for an 8.75 to replace my spool. thanks I seen this is a thread a few years back but couldnt find it on a search.

I cant seem to get the parking rod correct. when i install the valve body the parking rod is preventing the gear selector from moving either direction. I've tried to pull out parking rod by pulling on it and moving drive shaft back and forth with NO luck. looking at a pic of how rod should be...

installed a b&m shift improver on my 727 in my 68 dart. It goes into reverse like normal, then in drive gears it engages and takes off very slowly when taking off with not much throttle, then if i gas it hard it acts as though im doing an "neutral drop" and tires turn-over really good. shifts...

(68 dart 340) I am swapping 7.25 to 8.75. I bought correct A-body housing and axles staying with the 5x4 sbp so my cragers still fit. Problem is my old 7.25 backer plate wont fit due to wrong bolt patter and center hole to small for axle bearing to fit though hole in middle of plate. I do...

I have a 1968 Dodge Dart, it has a 7 1/4 rear end which just went out. Is there anyone in lower Michigan with a complete 8 3/4 that is for sale. Send me a email or call 269-273-3535 with what you have. Thanks Dan

I just replaced my speedometer cable with a new one. It didn't have any gears on the end of it, but now my speedometer shows about 15 to 20 miles faster than it is. What tooth of a gear do I need ? Thanks Dan