Search results for query: *

Should strut rods for a 64 barracuda look like this? I'm thinking it should be straight.

I finally took my barracuda out for some higher speed cruising. I got up to 65 and the speedometer was really really loud. Is there a way to properly lubricate the speedometer? Suggested oil to use and proper method? Thanks!

The trans in the barracuda feels like its slipping badly. Havent driven it enough to break it or wear it out. I just dropped the pan and filled it with the atf for all makes and models. Now its like it takes forever to catch gear. Kickdown is connected. Cranks fine. Could it be the cable out of...

The early A body 904 Shift Cable seal is a standard #10 O ring. I had to get one over the weekend and I figured I'd post this up here just in case someone needs the info.

Anyone have good pictures of an aftermarket Early A body sway bar installed? The one I picked up seems to be setup to mount to the axle, not the body like the factory one. This is going on my 64 Barracuda. Thanks!

Changed the speedo seal and now everything jumped a button on me. R is N and 1 doesn't push. Should I adjust the cable one click? Counter clockwise?

Changed my speedometer cable seals yesterday on the 64 barracuda. Since I know people were asking about it here are the o rings I used: Big O ring for the housing seal is a -057 standard ring. 1"x13/16"x3/32" cross section. Small O ring for the gear seal is a -078 standard ring...

So I'm thinking I really don't want to cut the floor pan on my car like I'd have to with the T5 or T56 or even a 200R4 swap. it's the cleanest I've ever seen on cars I've owned (minus my brand new dd). I had an 81 D150 with the Aluminum housing 4 speed with OD and that truck averaged 20...

So the original speedometer cable is leaking fluid out of the sheathing on my 64 Barracuda. The cable is the original push button 904 one. Where do I go about finding the seal? and do I have to drop the pan to get to it? I have a pan seal but I was hoping I wouldn't need it since the pan...

Before I read up on the SS springs I bought a pair, thinking they would do the trick for my setup. Now I'm thinking a stock height but stiffer was what Is should have gotten. I'm thinking about buying a house and I really don't have the cash to get another set of springs. My old springs...

It finally happened, I drove the car! Did the 25 mile trip from the garage I was formerly renting to my place without too many hassles. I did notice the carb needs tuning (too rich and doesn't idle well when it's warmed up), the temp gauge was creeping, I think I have a drip leak coming from...

I've always been a fan of the 63 and 64 darts, but I like the fast back roof of the Barracuda. The front clip on my 64 Barracuda is rough from a couple of accidents it looks like. It sounds like an abomination, but has anyone swapped the front clip from an early dart onto an early...

I went to get the Barracuda out of the garage for the season and ran into a few problems. Over the winter I put in Doug's headers, mini starter, new fuel pump, plugs wires cap and rotor, rebuilt the carb, and put on a 2.5" Exhaust. Topped off the fluids and put some fresh gas in the car...

What years will fit on a 64 Barracuda buckets? I'm not overly concerned with being Original since the original engine is long gone. I'd like to recover my front seats and I'm interested in what fits.

I was talking to a co worker who has a nice D150 with American Racing Vectors on it. He mentioned that he had another set of alloy wheels he was looking to sell that were for the truck. He brought them in and they are 15"x7" wide with between 4 and 5" backspacing (eyeballed it up with a...