Search results for query: *

Does anyone know the center to center width of the holes on the trunk lid to mount the pedestals. I am fairly certain that E-bodys are 36 inches apart. I have a go-wing that is around 33.5 inches. I am wondering what it came from, no part numbers on it. Thanks, Rod

I have my 71 Barracuda on its side working on the underneath and would like some opinions on if I should POR15 (or some other product) the bottom. I have heard some good things about POR15 and some not so good. Please let me know if you like the product. thanks, Rod

Not an a-body but applicable for any ABS plastic grill. I bought a 6x12x1/8 inch sheet of gray abs plastic off ebay for a few bucks. Cut up the pieces into small chunks, put in a small glass jar, and poured acetone about 1/4 inch over top of pieces. I let that soak for a day or so to make a goo...

I am fitting up my new sheet metal on my 71 Barracuda. I took some measurements prior to dis-assembly but would like verification that they are good measurements. I need the full opening width of the trunk. I have mine mocked up with sheet metal screws and am getting a 54 15/16 measurement...

Putting new quarters, trunk floor extensions, deck filler panel, and an outer wheelhouse in my 71 Barracuda. No wonder this costs a fortune if you pay someone to do it. It is a ton of work!!!

My passenger outer wheelhouse is beyond repair. Bought an AMD one and am figuring out my plan of attack. Rear quarters, trunk floor and extensions, and tail panel have already been removed. I don't feel any spot welds holding the two wheelhouses together. It is almost as though there is a...

So I did some research and found a chemist that said Krud Kutter Concrete Etcher was basically the same as SEM Rust Mort, and considerably cheaper. I tried the concrete etcher on my 71 Barracuda and was not that impressed. Bought some Rust Mort off Ebay for 25 bucks (quart). It is considerably...

My 71 Barracuda has a second smaller fender tag that has only 2D on it. Two door seems too simple, especially since they only made two door barracudas. This car is a two-tone car, could that be the explanation? Thanks, Rod

I spoke to a couple of paint guys and they suggested gluing on my quarters instead of welding. They say all the new cars use glue, has a 2800 pound strength, seals the edges, and is way easier than welding. I am doing a driver 71 Barracuda and don't really care that much if it isn't put...

Anybody have a good used 69 Formula S medallion or know if anybody makes a repro. This is the one that goes on the tail panel and is different than the 67/8. Rod

Anybody seen up close the reproduction 69 Barracuda trunk panels. I have been doing some side work to buy one, but want to know the quality of the piece before I plop down 450$. thanks, Rod

Okay, just bought a hemi hood scoop (68 Hemi dart/barracuda style) for a spare hood I have for my 69 383-S Barracuda. Does anybody have a drawing of where the hood scoop should be located on the hood? thanks, Rod

Anybody have any recommendations on who to send my 69 Barracuda trunk panels to have them restored. I have several that I aquired over the years. Based on the high prices I have seen for them, I thought I might be able to sell one or two of them to pay for the one going on my 69 383-S Fastback...