Search results for query: *

  1. twayne24365

    Lights..

    ok guys, lost brake lights the other day, checked the usual, replaced all fuses in fuse block, now with light switch off I have tail lights, turn signals work, hazards work. With switch on, I have no headlights, turn signals work sometimes, no brake lights, replaced brake switch.... headlight...
  2. twayne24365

    Not charging at 12 volts

    ok fellas, here's the run down... Fairly new battery in the trunk One wire 63amp alternator Msd6al ignition And really the only electrical accessory is a fuel pump. I had to replace the alternator due to a bad bearing, used to show 14volts with key on, then 12 volts while running. The...
  3. twayne24365

    running lights

    hello all, I lost my rear running lights and my tach/gauge lights. headlights, turn signals, and brake lights work, so does the dome light. put all new fuses in fuse panel as well and they still won't work, any ideas?
  4. twayne24365

    Distributor choice

    Going to get a new distributor, and its between the firecore or msd billit units. Any opinions? Looking for around 20 initial and 36-38 total
  5. twayne24365

    Slow cranking

    First my battery is relocated to the trunk, I bough a brand new 875 CCA battery and it cranks fine for about 4 revolutions then slows almost to a stop, hook it to the battery charger/jump box and it cranks like a champ. I was thinking maybe the cable from the battery to the starter isn't big...
  6. twayne24365

    Which alternator

    Hey guys, so I'm going with a 1 wire alternator setup and with all the options I'm just not sure what to get, I'm seeing everything from 40 amp to 110 amp, Chevy, Ford, and Mopar options. Now I don't seed some super chrome polished high zuke model lol. For electronics all I really have is an...
  7. twayne24365

    Ignition wires

    So I know to hook the small red msd wire to a switched 12v. From what I've read alot of people splice it into either the IGN 1 or IGN2 wire. And looking at the wiring schematic I can't find which wires they are. I'd like to tie it in under the dash not in the engine compartment. Thanks
  8. twayne24365

    Wiring help

    So I'm trying to fix the hack job mess from the guy that had the car before me. I'm switching to a one wire alternator and msd ignition. So I know the voltage regulator and ballast resistor get eliminated with the one wire alternator, and the old ignition module is eliminated with the msd...
Back
Top