2026 Race Engine Challenge

-
Carlo is leaving Ottawa

IMG_6455.jpeg
 
Icetech said:
ah that was it for today...

I am wondering if less cam might be more for this, guys seem to make massive peak power but the average is a bit low.. no actually sheet to look at though.
Click to expand...

Earlie A said:
You might be on to something there……
Click to expand...
The camshaft DEFINITELY needs to be tailored to the Judged rpm window.
 
Guys, the lifter bores have been corrected, but its 8:20 currently, and the block is one state away. We still have our spot if I can get the block back here early enough to assemble the engine, and make pulls tomorrow night. It seems ridiculous, but I'm kinda insane anyway
 
Icetech said:
They are arguing bout the raised runner thing
Click to expand...
Yes, chevy #2 has All Pro raised runner heads, which the rules prohibit in writing. Salter evidently told him they were ok to run, will be interesting to see if the rules are honored. The integrity of this whole competition depends on fair and honest rule enforcement.
 
NC Engine Builder said:
Despite my efforts, I dont have the head gaskets I need, so I'm not gonna make it unfortunately. Lord knows how hard I tried.
Click to expand...

Can't do more than your best, nice effort...

Yeah.. Salter showed pics of the heads and they look like stock location ports.. other guys there agreed
 
NC Engine Builder said:
Yes, chevy #2 has All Pro raised runner heads, which the rules prohibit in writing. Salter evidently told him they were ok to run, will be interesting to see if the rules are honored. The integrity of this whole competition depends on fair and honest rule enforcement.
Click to expand...

They basically said it's a learning experience and they will have to tighten things up.. i don't think they were done talking though.. they went outside off camera to continue
 
Icetech said:
Can't do more than your best, nice effort...

Yeah.. Salter showed pics of the heads and they look like stock location ports.. other guys there agreed
Click to expand...
Greg also asked him how can they be the same as stock if the location is raised, to which salter responded "I dont know"
 
Icetech said:
They basically said it's a learning experience and they will have to tighten things up.. i don't think they were done talking though.. they went outside off camera to continue
Click to expand...
That's a poor excuse, this is the like the 4th time they have had this competition, they had it a few times back in 16-17
 

My cam finally shipped from Jones :) hope i didn't piss him off too much emailing.. but wtf.. 3 weeks no replies.. and called and couldn't find out what was going on
 
just praying it's all right (not a slight against any cam guy at all.. but easy to make a mistake on a engine model you probably don't do many of) like the howards that had the oil holes not drilled all the way in one cam
 
Last edited:
You must log in or register to reply here.
-

Similar threads

R
Race Engine Challenge--North Carolina, April 17-18 2026
2
Replies
47
Views
3K
ValiantRacing
ValiantRacing
pittsburghracer
John Force replacement driver named
Replies
16
Views
3K
pittsburghracer
pittsburghracer
N
  • Locked
[SOLD] 1968 Valiant with R5P7 Dodge Nascar Engine!!!
Replies
1
Views
6K
NMCA Dave
N
Back
Top Bottom