360 & 340 Motor Mounts the Same?

-
DEVIOUSDUSTER

DEVIOUSDUSTER

Proud Member
Joined
Jan 7, 2009
Messages
220
Reaction score
8
Location
Minnesota
Quick question for the professionals out there.

I have a later model A-Bod K-member set up (disk brakes) that was used for a 360 but now I want to install a stroker 340. (418 c.i.) Can I reuse the same engine mounts? Will it bolt up the same?

Let me know what you know!
 
when I went from a 360 to a 318 I had to use washers as spacers for the mount ears on the block. The 360 has wider cast ears on the block on the drivers side than a 318, I think the 340 as well.
 
Thanks for the fact check guys. It looks like Shumacher has a replacement kit and both the mounts are the same. I just hope the kind of k-member doesn't matter either.
 
Not up on Schumacher's mounts, just make sure their mounts are for the spool K. You have the spool K and the mounts will fit if for that style.
 
You must log in or register to reply here.
-

Back
Top