Attemptnumber2
Member
I pulled the valve cover on the new to me dart to try to quiet the lifters a bit. Set lash at whatever the recommended is. Started it and no change.
There is a large amount of side to side movement for the rockers. Without measuring I would estimate a sixteenth of an inch or so. Probably 3 or 4 of them like that and that was where I could narrow the bad tick down to.
I focused on small adjustments in that area and had no change. I can only narrow it down to the lifter to shaft being the cause. I fully understand a little lifter noise is acceptable but this is not a little.
Any thoughts?
There is a large amount of side to side movement for the rockers. Without measuring I would estimate a sixteenth of an inch or so. Probably 3 or 4 of them like that and that was where I could narrow the bad tick down to.
I focused on small adjustments in that area and had no change. I can only narrow it down to the lifter to shaft being the cause. I fully understand a little lifter noise is acceptable but this is not a little.
Any thoughts?