Alright this is my first post so go easy on me.
67 Barracuda 383 4 speed for what it’s worth.
My parking lights (front and rear) and dash backlighting come on when turn the key to either run or accessory with the headlight knob fully pushed in. When I adjust the dimming knob on the light switch with the knob in, my parking lights (front and rear) adjust from off to bright, not the console lights. When I pull the knob out to parking or lights on there’s no adjustment with spinning the knob. Brand new switch put in today. Same behavior with old switch. All wires are in their correct spot according to the diagrams. I believe the hazard switch is bad. Not sure if this is the cause. Someone mentioned on Facebook it may be the turn signal switch. Brake lights, parking lights and turn signals all function normally other than the above issues. Hope this makes sense! I’m stumped as all get out.
67 Barracuda 383 4 speed for what it’s worth.
My parking lights (front and rear) and dash backlighting come on when turn the key to either run or accessory with the headlight knob fully pushed in. When I adjust the dimming knob on the light switch with the knob in, my parking lights (front and rear) adjust from off to bright, not the console lights. When I pull the knob out to parking or lights on there’s no adjustment with spinning the knob. Brand new switch put in today. Same behavior with old switch. All wires are in their correct spot according to the diagrams. I believe the hazard switch is bad. Not sure if this is the cause. Someone mentioned on Facebook it may be the turn signal switch. Brake lights, parking lights and turn signals all function normally other than the above issues. Hope this makes sense! I’m stumped as all get out.
Last edited:















