dave273dart
Well-Known Member
A few day ago I installed a new Edelbrock 2176 Intake. The first day I drove it it was fine. I went to take it out yesterday and noticed that coolent was comming from the overflow hose and then I noticed bubbles and coolent comming from a couple bolt holes and along the intake. I put in a new thermostat at the same time I did the manifold. I started the engine with the radiator cap off to move it into the garage and there was no water comming from the intake?? At first I thought it was the thermostat, so I took it out this morning and and put it in hot water, it opened fine. The engine only has 890 miles on it. I pulled every plug and no water in the cylinders???? Things were working fine until I installed the intake. When I built the engine the heads were milled .050 and the same fellow milled the intake. What am I missisng. By the way I am 69 and getting toooo old to pull engines apart. Thanks for any assistance.
Dave
Dave