[WANTED] 67 glove box handle

[4spdragtop]

Well, looks like I learned there is differences in 67 barracuda glove box doors. Difference is in the mount hole opening between the standard handle and the "upgrade" lock/handle. I didnt realize the difference and now have a glove box designed for standard handle....
So to rectify I either need a standard handle OR a glovebox door designed for upgrade handle(that I have).
Dammit all, anyone got a nice glove box door or a nice standard handle?
Thanks
Steve

 

[Dana67Dart]

Steve, is the opening on the inside of the door stamped differently?

Post some photos.

 

[cudascott]

Steve, is the opening on the inside of the door stamped differently?

Post some photos.

The opening in the door for a “standard” pull handle is a screw hole with a second hole that locates the handle via a small pin cast in the pull handle . The door for a locking latch has a hole big enough for the cylinder to pass through.

 

[4spdragtop]

Yep, different....I just figured it out now...I already sold the other(orig) door as it had a few pits.

Steve, is the opening on the inside of the door stamped differently?

Post some photos.

The opening in the door for a “standard” pull handle is a screw hole with a second hole that locates the handle via a small pin cast in the pull handle . The door for a locking latch has a hole big enough for the cylinder to pass through.

 

[Dana67Dart]

I was trying to see if you could just drill a hole, guess not.

Are the dart and Barracuda doors the same?

 

[Cuda Al]

67 Barracuda only for the door
67 Barracuda/Valiant/Dart for the handle or lock/handle


Alan

 

[Dana67Dart]

too bad I have a 67 Dart door i could part with if you needed one in the short term

 

[4spdragtop]

Got a pic?

too bad I have a 67 Dart door i could part with if you needed one in the short term

 

[Cuda Al]

Got a pic?

You might be able to drill the holes to mount the trim.


Alan

 

[4spdragtop]

I dont trust my drilling on a freshly powdercoated glovebox.
Hoping I can find a decent standard pull in the meantime. Thanks.

You might be able to drill the holes to mount the trim.


Alan

 

[cudascott]

Hey Steve,
You may know this already but the handle pull is reproduced. Not cheap though.
MA1827 - 1967 Dart, Barracuda, Valiant; Glove Box Handle; Hardtop; w/o Lock Cylinder

 

[4spdragtop]

Thanks Scott, I'll chk them out.

Hey Steve,
You may know this already but the handle pull is reproduced. Not cheap though.
MA1827 - 1967 Dart, Barracuda, Valiant; Glove Box Handle; Hardtop; w/o Lock Cylinder

 

[Capt46]

I think I have one. I’ll check later if you haven’t found one yet.