[Found!] 8-3/4 741 Pinion Spacer

[Sportfury70]

I need a 741 pinion spacer, crush collar, pinion sleeve, whatever you want to call it. I have everything else but that sleeve to put this thing together.

Let me know if you have one laying around!

 

[Jim Ward]

I need a 741 pinion spacer, crush collar, pinion sleeve, whatever you want to call it. I have everything else but that sleeve to put this thing together.

Let me know if you have one laying around!

Do you have a photo for reference? Probably not if you’re missing the piece but I may have one.

 

[Sportfury70]

Do you have a photo for reference? Probably not if you’re missing the piece but I may have one.

 

[Jim Ward]

Ok I don’t have one of those, sorry.

 

[RustyRatRod]

Crush sleeve eliminator. Dr. Diff has them.

 

[crackedback]

Crush sleeve eliminator. Dr. Diff has them.

That's 489 case stuff.

 

[Jim Ward]

I thought the 489 case was the only case to use a crush sleeve.

 

[RustyRatRod]

That's 489 case stuff.

Well, he posted a picture of a crush sleeve eliminator.

 

[RustyRatRod]

They have a spacer like a sleeve eliminator to set bearing preload.

Ok. My bad then. I haven't set many of those up at all and it's been a long time. I actually HAVE a whole 741 chunk out here with 3.23 gears on it, but I've only swapped an open carrier into it and put the sure grip in something else, so I didn't get into it far enough to remember. But Dr. Diff should still have that, I would think.

 

[Sportfury70]

I sent an email to cass to see if he’s got one.

741 and 742 have the spacer, 489 has the crush sleeve. The pic is the actual spacer for a 741, it’s on eBay but I’d prefer to get it elsewhere before risking eBay. I don’t have the best luck there.

 

[oldkimmer]

742 does not have that spacer. Kim

 

[RustyRatRod]

I sent an email to cass to see if he’s got one.

741 and 742 have the spacer, 489 has the crush sleeve. The pic is the actual spacer for a 741, it’s on eBay but I’d prefer to get it elsewhere before risking eBay. I don’t have the best luck there.

I completely understand.

 

[RustyRatRod]

Hay yall. It just now downed on my dumb *** that this is a wanted ad. We're not supposed to comment. My apologies, @toolmanmike.

 

[toolmanmike]

Hay yall. It just now downed on my dumb *** that this is a wanted ad. We're not supposed to comment. My apologies, @toolmanmike.

No problem. It was already off the rails.

 

[moparraceman]

what the lenght and diameter of the sleeve might nave a new one

 

[Sportfury70]

what the lenght and diameter of the sleeve might nave a new one

I would assume the ID is about 1-3/8 for the 741, but I have no idea of the length or OD. Haven’t found that online yet

 

[Big.J.007]

I have a good used 1 from a 741 case.

 

[Sportfury70]

I have a good used 1 from a 741 case.

Pm’d

 

[Sportfury70]

Found, thanks gents