[WANTED] 8 3/4 large u-joint yolk 10 spline

[RTK_line]

Looking for a reasonably priced 10 spline yolk for an 8 3/4 rear end(large u joint type). Also need a nut and washer for the pinion. P M me thanks.

 

[chignikred]

I have a beaded, painted, nice one, with new caps. have nut and washer. $85 shipped.

 

[physixx]

I have a new yoke with straps but do you need the large or small diameter nut and washer? The pinions come in both sizes. I just did a 10 spline 742 rear that had the smaller diameter nut and washer.

Ken
Edison, NJ

 

[RTK_line]

I have a new yoke with straps but do you need the large or small diameter nut and washer? The pinions come in both sizes. I just did a 10 spline 742 rear that had the smaller diameter nut and washer.

Ken
Edison, NJ

I'm not sure about the nut and washer. I let a friend borrow the yoke off my spare pumpkin and never got it back.

 

[physixx]

Nice friend! The smaller pinion thread is a 3/4-16 thread that uses a 1 1/8" socket. Not sure about the large thread but might be 13/16" NF using a 1 1/4 socket. I have both along with the yoke.

 

[SGBARRACUDA]

If your still needing one, I have one also.

 

[fishy68]

I have a new yoke with straps but do you need the large or small diameter nut and washer? The pinions come in both sizes. I just did a 10 spline 742 rear that had the smaller diameter nut and washer.

Ken
Edison, NJ

All 10 spline used the small nut/washer. The 29 spline uses the large nut/washer. The spline count is the split in size

 

[physixx]

Good to know. Thank you.

 

[fishy68]

Good to know. Thank you.

Your very welcome sir

 

[Mojack]

If your still looking, I have a couple: