rapidtransitric
LX/LC platform a body swap pioneer
plum demon nice design do you sell those or are they just one off's
plum demon nice design do you sell those or are they just one off's
while they may look clean installed think about it you are using a relatively weak floor as your top portion of your box, so you have a thicker U then a weak floor.......... I would use a nice thick wall box and make them yourself. Thought they are a lot better then nothing.
while they may look clean installed think about it you are using a relatively weak floor as your top portion of your box, so you have a thicker U then a weak floor.......... I would use a nice thick wall box and make them yourself. Thought they are a lot better then nothing.
i still have negitive thoughts about welding these in on a rotiserie , ive heard when on them the body might tend to sag or twik a little , i was told to lower down to the ground and install the springsand stands in back and jack stands in front under frame and let sit a week or so to let it respring itself for a while, then tach weld the connectors and then raise and finish weld , can anybody add some view point to this , the latter does sound logical ? thanks dartman 440
Woot they finally have them!
Laser cut from 11 gauge steel, these are designed to follow the contour of the original floorpan and be welded directly to the original floorpan for maximum strength. $170
http://www.uscartool.com/Aframeconn/index.html
you think they are as good as the 2x3?
Do they have them for the 111" wheel base?
Are they already notched for the fuel lines. I got mine but have not taken out of the box yet? also brake line on the drivers side?Here are some pics of the US Car tool frame connectors on my Dart. They were just installed a week ago or so.