A pillar molding

-

itsdiz

Active Member
Joined
Sep 4, 2015
Messages
44
Reaction score
52
Location
New Mexico
Does anyone have an extra set of A-pillar moldings for a 1965 (64-66 I think would fit) Barracuda? I didn't even realize mine were missing until I installed my new headliner today. I found one small piece where it fits over the dash and some other broken plastic pieces which I am guessing were part of it. Or where can I buy new ones? I checked Mopar Mall, and Mr. Moparts but didn't see them listed. I found some on eBay but $239.00 for the pair, and the listing says A Body, but only shows Darts, not sure if they are different, or if those are just the models the seller chose to list. Found another set for $220.00 which says will fit Barracuda and they look the same?

Afterthought - could also use a pair of trunk hinges, mine are worn out, these would have to be 1964-65 I guess, I looked at a '66 in a yard but it had the long square tubular arm type.

a pillar molding.jpg
 
Last edited:

'64-6 2DR HT's should all fit, including the Barracuda. I'll check to see if I have any spares. I should have the trunk hinges too.
 
-
Back
Top Bottom