inkjunkie
Well-Known Member
Blew the cob webs out of it. All the connections were clean and tight. Took the feed wheel off and cleaned it. Backed the tension way down. Pulled out the liner that was in it and put the old one I saved back in it. The one that I removed was a generic one....that I cut about 3/8" too short. The one I put in was a Miller one....for .035 wire. Welds like there is no tomorrow now. No sputtering, no uneven feed.
I noticed the liner was not able to go up into the gas nozzle from me cutting it short. Hmmmm......wonder what the problem really was? I am even using the old .023 spool, the one that has been sitting out in the garage for 6-7 months or so.....
I noticed the liner was not able to go up into the gas nozzle from me cutting it short. Hmmmm......wonder what the problem really was? I am even using the old .023 spool, the one that has been sitting out in the garage for 6-7 months or so.....