buckets seats install

[unknownsnake]

Ok well I was test fitting my buckets in my car. Its a old beach seat car. Do I use the two holes for the bench and make two more or center seat and make four holes? I tried the beach seat holes and the seat looks not centered at all:banghead:

 

[Purple Haze]

Guess you answered your own question. After you drill the holes weld a piece of 4" square X 1/8" plates over the holes and re drill the plates.

 

[pauly v.100]

are the buckets from a mopar?
if so, look for small dimples in the floor on the center hump side, those are the mounting points for the inner bolts. then, if the outers don't fall into the bench seat holes drill new ones. i think there's dimples for the outers too but not sure.

 

[1972DusterPaul]

Find the dimples...the P.O. of my Duster drilled 15 holes...most of them were off the mark...this is my after picture.

Paul

 

[unknownsnake]

I knew i should have put seats in before the heat liner......

 

[Snake]

My 69 was bench and if ya can see in the pic I also welded plates.

 

[Tony Fields]

Here's the dimples

 

[unknownsnake]

well looks like im going in to tear heat liner out....

 

[1972DusterPaul]

The above pictures should give you a pretty good idea of hole location...so you shouldn't have to tear too much up.

Paul