N1ce2k1llu
Well-Known Member
Setting up an Edelbrock proflo 4 system and the ecu wants to know my camshaft profile. What number am I looking for?
If it asking for the 'Cal ID' as in the instructions near the back for the Setup Wizard Map Matrix, then go by the duration on your cam card at .050" lift....
On your cam card, that is 219 IN and 227 EX. I would go by the intake number.
If it asking for the 'Cal ID' as in the instructions near the back for the Setup Wizard Map Matrix, then go by the duration on your cam card at .050" lift....
On your cam card, that is 219 IN and 227 EX. I would go by the intake number.
OK. I see your pix posted from the screen.Thanks. On the setup wizard it just asks " Camshaft Profile"
Thanls , What you said does make sense about going off the map matrix. The instructions say nothing about @.050 so I am still wondering.
View attachment 1715537948