camshaft again

-
nesse

nesse

Well-Known Member
Joined
Mar 28, 2010
Messages
51
Reaction score
0
Location
sweden
what cam suit best for my new combo 360 :
edel-heads , rpm airgap, holley 750vac, 10.5 cr,
roller-tip rockers-1.5,tti step headers 1.5/8-1.3/4, 2.5inch pipes dyno max mufflers, 2600rpm stall, 3.91 s-grip.

have a nice day
 
This cam will work great.

Your converter is way to tight for anything bigger.

DO NOT GO OVER 240 DURATION @ 50.
AND KEEP IT A TIGHT CENTER LINE FOR MORE LOW END TORQUE.

WHAT COMPANY MADE YOUR CONVERTER???????


ISKY CAMSHAFT

280-MEGA High performance use/bracket racing. Lopey idle. 2500 Stall. 9.5-10.5:1 compr. 3.90-4.11 axle ratio. Up to 780 CFM Carb. RPM-Range (2500-6800) Valve Lift (.485 .485) Valve Lash hot (.000 .000) ADV Duration (280 280) .050 Duration (232 232) LC 108 390181 $132 390081 $809
 
75/25?? Go to comp cams and download camquest6. Even if you dont buy one of their cams you have a good baseline for selection that will apply to other manufacturers.
 
The Lunati "voodoo" 60404 cam should work fine,my 360 combo is very close to yours,although i'm running a 850 carb,3800 converter..but what you have should work fine..its put my 360 in the 11.70's...and with good street manners..
 
hello, back again, thanks for info and all advice, don't know the company who built the converter, check my stall yesterday and i was surprised (2600rpm) because when i cruise around it feeld like stock but when i hit the floor the engine rpm speed upp to 2600 and pulled strong up to 5000rpm when the cam stopp pull more...that i mean about 25/75% just street/strip and i go for hyd-cam / have a nice day
 
when are this cams realy pull hard in the rpm range and what hp/tq ? The hughes cam don't give much rpm, can this realy give some nice power, and isky have no "split" profile are that an old grind, because what i understand so are all "new" cams split profile like the hughes and lunati...feel a litle dizzy aboute to pick the right cam, whant to do the engine and car so much
muscle power as i can for the money, i allready have 2 compcams: one to "mild" (275deh) and
one to "hot" (xe295hl) and 2 set lifters that i can use one for a new hyd-cam/have a nice day
 
That XE275HL is a nice cam. I'd use it.

Understand this. When it comes to cams, the choices are many. The difference in power between similar cams is very low. It becomes silly to be so precise on choice. It is very similar to choosing the right sock to wear for a game of soccer.
 
silly! ? ! , so you mean that if i pick a cam with .250dur and 545 lift and one with .230dur and 510 lift, rpm range 2500-6000rpm, power get the same hp/tq with a litle difference !? And about "silly" that is the one who say it WAS IT
! ! ! ! ! ! ! ! !
 
I'm talking about splitting hairs between two camshafts of extremely similar specs from 2 different companies. That is silly.
 
You must log in or register to reply here.
-

Back
Top