Correct Z Bar for a ‘65 Barracuda-273 and 833 transmission

[magnus0328]

Good evening

I have a ‘65 Barracuda with a 273 and a 4 speed 833 transmission. I’m seeing 2 different Z bars for it. Can someone confirm which is correct?

One has a straight arm and the other one has a curved arm, see photos

Thanks

 

[RAT ROD AL]

I believe the top one is correct. Go on Brewers 4speed parts and compare !

 

[magnus0328]

I believe the top one is correct. Go on Brewers 4speed parts and compare !

That’s the issue. Both Brewers and eBay show they both will fit

 

[RAT ROD AL]

I parted a 64 Dart . and it looked like the top one you have above .

 

[junkyardhero]

i just did a 65 dart, used the top one.

 

[Dan Brewer]

That’s the issue. Both Brewers and eBay show they both will fit

First pic is correct.

Your second pic is for 67 and newer A body with BB. No where in my description does it say it fits the early A body with 273.

 

[magnus0328]

First pic is correct.

Your second pic is for 67 and newer A body with BB. No where in my description does it say i

First pic is correct.

Your second pic is for 67 and newer A body with BB. No where in my description does it say it fits the early A body with 273.

The second pic was taken from an eBay ad

The one for yours says it fits a 63-66 A body with a 10.5 bell. I’m going with yours, but wanted to make sure I was getting the right one. This photo is from the eBay ad

 

[Dan Brewer]

The second pic was taken from an eBay ad

The one for yours says it fits a 63-66 A body with a 10.5 bell. I’m going with yours, but wanted to make sure I was getting the right one. This photo is from the eBay ad

View attachment 1716438345

The eBay add is wrong, it's that simple. I don't know that seller...

 

[magnus0328]

The eBay add is wrong, it's that simple. I don't know that seller...

Thanks