Hilderbrand1983
Well-Known Member
Well ... that doesn't appear to be possible. My radio bezel is integral with the rest of the heater control bezel.
Dart radio with thumb wheels
- Thread starter Hilderbrand1983
- Start date
-
It looks that way. I wonder if 67 is different.
Here is what I did with my bezel.
Note the 3 screws (not stock)
The squared off bezels in posts 19 and 20 above are NOT for a 67 with GT trim and will not fit.
If the screw posts on the back are intact, ( not the blade shaped ones) I would have it restored.
Note the 3 screws (not stock)
The squared off bezels in posts 19 and 20 above are NOT for a 67 with GT trim and will not fit.
If the screw posts on the back are intact, ( not the blade shaped ones) I would have it restored.
Hilderbrand1983
Well-Known Member
Well ... one screw post is intact. However, wouldn't one be all I need? I think the screw posts in the 67 were meant to help anchor the bezel onto the dash (because the plastic tabs were a terrible design). If I'm going to drill holes through the front of the bezel, there shouldn't be a need for two screw posts. One would probably suffice to stabilize the heater control against the bezel.
Sorry, my point was if the screw posts in the back are intact you wouldn't need the front screws.
If the posts were gone like mine, you could use screws like I did or you could probably use an adhesive but removing it in the future would be a bear.
If the posts were gone like mine, you could use screws like I did or you could probably use an adhesive but removing it in the future would be a bear.
-
