Does that wheel look a little funny to you?

[phaelax]

Got the new spindles and bearings installed. Test drive went fine, needs a slight alignment though but that was needed before all this. Gas cap says its out for delivery today already, so that's good news. And yes, I drove without the gas cap cause frankly I totally forgot it was missing.

In a bit of unrelated news, there were some pretty nice cars at a local show saturday, one being probably one of the nicest 340 4spd dusters I've seen in an unusual dark red and what I considered the best in show, a '70 hemi challenger convertible.

 

[Dana67Dart]

when you get the gas cap post some photos. Im looking for a cheap oem style gas cap that I can cut up and make a fuel filler bezel so the pump trips off and doesn't pour down the side of the car.

 

[phaelax]

I got the cap yesterday, but then some kid cut my cable line in the yard while burying another line. Despite reviews of all the vehicles folks say it fits, it would not fit mine. The smaller tabs that tighten the cap when you turn it would not match up to the notches. The actual part was MotoRad MGC800. I ordered mine from Sixity Auto, but it looks like it's on Amazon for only $9.

 

[Swinger 340]

Looks like my GM cap from my 73 truck. Nothing like any Dodge caps I had.

 

[Dana67Dart]

That's too bad.

There are several posts with a photo of several caps lined up and the years they go to

 

[nutz]

And it's shiny

 

[phaelax]

Aside from being shiny, it looked like my old one I think, minus the orange piece. And the label, but that looks like that's only attached by the screwed holding the handle on. I was just gonna spray this one black if it fit.