Slappy
Well-Known Member
I want to bolt a 360 to my engine stand. Does anyone know what size and exact length bolts I need to bolt it to my stand???
I get 6 inch (or longer) bolts, put a jamb nut all the way on, thread the bolts through a washer and the stand into the block, finger tighten (making sure plenty of the bolt goes in the block), then I run the jamb nut down and tighten snugly (don't over tighten) This has always worked for me, got three engines on stands dome like that right now!
What do others think?
If you do hacksaw some allthread to make your own hardware, dont forget to chamfer the cut ends. Safety first
I use grade 8's. Measure and buy.
X2 never use althred is only grade2 to much money hanging there to try and save 4bucks.....and if you put it on the stand write you should be able to rotate it with the heads on it with no trouble.I use grade 8's. Measure and buy.
X2 never use althred is only grade2 to much money hanging there to try and save 4bucks.....and if you put it on the stand write you should be able to rotate it with the heads on it with no trouble.