Snake
Mopar Nut
I have started to remove the pig,I loosened up the 10 bolts up last night and let it drip into a deep pan,this oil only has 2 tho miles.reuse or buy new. thanks,not looking forward to lifting the next pig up ale:.
Do you have to pull the axles to get the pig out ?
Do you have to pull the axles to get the pig out ?
Yup sure do.Just did it.I am removing old 1 leg and putting in an suregrip
If diff fluid is good for 30K, im going to need to go and change mine about 5 times in my truck!
if he were to have the green bearings instead of tapered would he need to take the thrust buttons out of 3d member? Thanks dustin
yessssssssssssss from what i have learned
Thank you. Maybe that explains my rears chatter around tight corners. Dustin
Some folks have said they didn't take them out and had no problems. It is recommended to remove them.
Which do you have clutch or cone?
Do you have the friction modifier additive in it?
If you don't that might be your issue.
Friction modifier is kind of a misnomer, it doesn't increase friction, rather it reduces it to allow the clutches/cones to slip a little under normal driving conditions to help alleviate the chatter.
Let us know how it goes.
On to the garage to rebuild my Demon carb.