Hedman fenderwell header pics

[496dart]

Mods--this might be a good one to sticky >>>>>

Here are some pics of my car with the new headers . Hedman Hustler fender well headers (VERY nice quality) , RB motor in 70 Dart . Schumacher stock type motor mounts. 727 , no power steering or power brakes.

These pics should answer a lot of questions about clearance . O

 

[496dart]

more

 

[496dart]

You see the paint bubbling up ?
Thats Eastwood header paint , $38 a can .
headers were prepped and cleaned twice , followed all their directions, ..eastwood says to run them on your engine for 20 minutes to cure the paint.

I ran it for 4 minutes today and you see the results.

 

[496dart]

If you arent using a motor plate , you will have to "clearance" the areas around the shock towers . I used a BFH and just touched up the paint (this aint no show car)

 

[pettybludart]

Good pics!Good idea about the sticky too!Here,s my Heddman Huslers on my 410 SB with solid mounts.
View attachment car pics 66 Dart 141.jpg

View attachment car pics 66 Dart 196.jpg

View attachment car pics 66 Dart 136.jpg

View attachment car pics 66 Dart 194.jpg
View attachment Racing the 66 Dart 026.jpg


496 this year I,m adding some rubber mounted supports at the collectors.One of my tubes cracked at the flange#-o last season.(fixed now)Just a heads up.

 

[496dart]

Post some pics of the mounts when you do it -- definitely a great idea ! I had that problem with ALL the Hooker headers i had --they all cracked open every other week . The Hedmans seem to be MUCH higher quality than the Hooker.

 

[496dart]

Is that the Hedman coating ? Has any of your blue paint burned off?

I just touched up all the burned areas in my pics, but the Hookers burned the **** out of all my nice orange paint

 

[pettybludart]

I haven,t had any burned paint with these being coated $$$$,you can actually work on the engine after about 10mins after a pass.I can also hold my hand about 3-4 inches from them after shutting down.The coating works amazing and no discolouring so far(after 1 year)

 

[barra72cuda]

do u have part number for those hedman hustler fenderwell headers

 

[496dart]

75160

so...3 years later---no cracks or problems with the hustlers