Help! Edelbrock 3275 Streetmaster for Chrysler 318
- Thread starter Bossman
- Start date
-
Pics of manifold and ports. I'm not finding much on this one.
I just saw a few pics. It will work but not the best. Low rise, open plenum. About like the stock HP273 intake. The old LD4B is a better intake I think. A dual plane works better with teens on the street.
sireland67
Well-Known Member
That is not that great of a manifold, but it will work if you are just changing from a 2bbl to 4 bbl.
Ok thanks. Yes that’s what I was going to do just to get car running again and while I restore it until I start upgrading everything.
sireland67
Well-Known Member
You will be fine, just bolt a square bore carb on it and be done.
I am really liking the new 625 street demon carb, it a bolt on, slight adjustment carb, for a daily driver.
Way better than any eldebrock, for the same price.
I am really liking the new 625 street demon carb, it a bolt on, slight adjustment carb, for a daily driver.
Way better than any eldebrock, for the same price.
Oh cool. I’ll have to check it out. I have a edelbrock carb but it’s a marine carb that fits it. Someone told me it may work just while I mock everything up and then switch it out.
sireland67
Well-Known Member
If you have the carb, at least try it.
Yes, if you just need something to get it running the intake and carb should work. You may have to engineer the throttle and trans. kickdown but a new intake and carb won't help you out there.
Yeah going to try it out. So if you have a minute I have another question for you. I’m restoring a 1950 Chrysler windsor. It has 3 on the tree. Original steering column. I’m trying to see if this is the kit I need to make the shifter work on the column with the 318/727 combo I installed. ididit Steering Column Cable Shift Linkage Kits 2801750010
-
Similar threads
- Locked
- Locked
