67dartgtgo
Well-Known Member
I’ve heard some of you say how you’ve done this and didn’t want to pull my motor so made up the 4x4 inner fender supports and suspended my motor from threaded rod into the intake manifold.
Pretty clever. Did the weight on your inner fenders affect them?
!!YUP!! An earlier thread
K-Member Removal with Engine in Place?
I don't remember I think when I did this I put "jack" 2x4's between the 4x4 across and went down to the frame.
Wow, that is over the top, even has holes to air out the block through the water pump openings!I built an engine support from some square tubing and some laser cut brackets.
View attachment 1715441546
Of course you did, Andy. Of course you did...I built an engine support from some square tubing and some laser cut brackets.
View attachment 1715441546