Is there some kind of boot over a console shifter

-

pauls340

Well-Known Member
Joined
Dec 4, 2008
Messages
842
Reaction score
51
Location
17 miles N of Detroit
Just took the Demon for its first test run today with the new console. After about 10 minutes the console felt like 250 degrees! Is there supposed to be a boot over the shifter under the console? The ashtray wasn't in and when I opened the door it felt like a hair dryer on high heat. Anyone know what I can do? Thanks
 

Attachments

  • Abody Console 4spd Mine.jpg
    97.9 KB · Views: 114
yea...put down some hush mat and then some of that Lowe's metallic bubble wrap (Insulation found in the water heater department).

Look for any holes that may be open to below and plug them as well.

Without insulation the hump is like an oven.

Good luck.
 
It got so hot you can see where the 3M glued carpet is starting to come off. I'm wondering if I should take the old nonconsole boot and put that back on then bolt the console over it? There is no way MaMopar made it this way.
 
I don't have any photos but mine has a lower boot to insulate the floor from the console. toolman
 
-
Back
Top