Just bought a tool I'll only use once

-
MrJLR

MrJLR

Built, not bought
Joined
May 14, 2015
Messages
5,593
Reaction score
6,578
Location
Menifee, California
Hopefully at least....!
But it's one of those tools you really gotta have to do the job right.....

image000000-4.jpg


Jeff
 
Is that a clutch pack compressor?
I use something much different that includes my vise.
 
MrJLR said:
That looks awkward

Jeff
Click to expand...
It's a one inch slice of c bar laying on its side. I had to whack it in the Middle with a big hammer on the cement floor to get to spread out just to the perfect setting. I used it for getting the clutch packs in and out of a 904 drum.
 
j par said:
It's a one inch slice of c bar laying on its side. I had to whack it in the Middle with a big hammer on the cement floor to get to spread out just to the perfect setting. I used it for getting the clutch packs in and out of a 904 drum.
Click to expand...
Hey.....if it works :thumbsup:

Jeff
 
Harmonic balancer puller,3-4” bolts and 6 nuts. Nuts used to hold bolts as standoffs,and a threaded rod in vise. Worked very well. I actually drilled a hole in bench to run threaded rod into instead of the vise.
Also had cut a hole big enough in bench to stand transmission up,grabbed it about midway, was much easier to assemble. But its been 20 +years since i was in one. Wont be long i will be exploring the innards of the 904. Will see how much i forgot.
 
MrJLR said:
Hey.....if it works :thumbsup:

Jeff
Click to expand...
Oddly enough I seen somebody trying to put one in one of those contraptions and I thought to myself watching that guy wrestle that thing in and out of there was even harder than actually putting it in my vice and doing it LOL
 
Tooljunkie said:
Harmonic balancer puller,3-4” bolts and 6 nuts. Nuts used to hold bolts as standoffs,and a threaded rod in vise. Worked very well. I actually drilled a hole in bench to run threaded rod into instead of the vise.
Also had cut a hole big enough in bench to stand transmission up,grabbed it about midway, was much easier to assemble. But its been 20 +years since i was in one. Wont be long i will be exploring the innards of the 904. Will see how much i forgot.
Click to expand...
Yeah it would be like forgetting how to read or something I would think? LOL it would take at least 20 years of heavy drugs for me to forget how to do that. But let me get started! Lol
 
Well I got to use it yesterday....worked freakin great!
The ears did want to slip out of the snap ring grooves so I just put little c-clamps on them....no problem after that.

image000000-9 (2).jpg

image000000-6 (2).jpg


Jeff
 

You must log in or register to reply here.
-

Similar threads

Inertia
Mac Tool Question ?
2
Replies
35
Views
2K
RustyRatRod
RustyRatRod
H
Adventures in wrenching.....who makes a decent tool these days?
2 3 4
Replies
75
Views
4K
JC71340
JC71340
Cruisingram
Die grinder and bits for porting- it's been a while
Replies
16
Views
575
azaustin
azaustin
63SplitWindow
US Car Tool
Replies
12
Views
1K
Kendog 170
Kendog 170
63SplitWindow
US Car Tool
Replies
12
Views
594
mosleyme
mosleyme
Back
Top Bottom