[SOLD] like new M1 FOR S/B
- Thread starter moparraceman
- Start date
-
- Status
That is a MoPar “M1 single plane” intake.
“Air Gap” is an Edelbrock buzz word.
If you can, post the numbers on the intake. A W5 M1 looks identical to it with off set bolt holes.
(FWIW, I’ve been sold a W5 intake by mistake before.)
GLWS
“Air Gap” is an Edelbrock buzz word.
If you can, post the numbers on the intake. A W5 M1 looks identical to it with off set bolt holes.
(FWIW, I’ve been sold a W5 intake by mistake before.)
GLWS
moparraceman
Well-Known Member
p44552893 the M1 doesnt have the air go under the carb does it ? when i bought this intake the guy said it was a air cap by mopar not edelbrock thanks
This is how it was explained in a thread on Moparts:
"P4452893 is actually the casting number.......for 2 different intakes.
The P4529460 was machined to fit the raised ports of the W-5 head.
The P4452891 was machined to fit the factory LA heads, Edelbrock,
Indybrock, Brodix B1-BA, Small Port Commando.
If you have an intake with P4452893 on it and the bolt spacing
matches your heads, it will work."
"P4452893 is actually the casting number.......for 2 different intakes.
The P4529460 was machined to fit the raised ports of the W-5 head.
The P4452891 was machined to fit the factory LA heads, Edelbrock,
Indybrock, Brodix B1-BA, Small Port Commando.
If you have an intake with P4452893 on it and the bolt spacing
matches your heads, it will work."
moparraceman
Well-Known Member
so is it a M1 or a air cap ?
- Status
-
