green1
Well-Known Member
Installed a new eddy 750 on the 440, was playing with the springs, etc, ran out of gas, more gas, re-started (was fine before); lifters clattering, no oil pressure.
Pulled the dist and intermediate shaft, spun cc with priming rod, get 5 #. 300 miles on the engine, always had 45 at idle. The 2800 rpm drill never really bogged down, and seems to spin up at times, like sucking air again.
Before we start tearing the world apart; pump? pick up? relief spring? lifter laying in valley? It was almost tuned perfect until the last primary rod change. Mech gauge.
Pulled the dist and intermediate shaft, spun cc with priming rod, get 5 #. 300 miles on the engine, always had 45 at idle. The 2800 rpm drill never really bogged down, and seems to spin up at times, like sucking air again.
Before we start tearing the world apart; pump? pick up? relief spring? lifter laying in valley? It was almost tuned perfect until the last primary rod change. Mech gauge.