69fastbackfish
Well-Known Member
new bell housing flywheel and clutch, now the mini starter turns engine about a 1/4 turn and stops. any ideas?
new bell housing flywheel and clutch, now the mini starter turns engine about a 1/4 turn and stops. any ideas?
Bought a mini off eBay new aftermarket china junk and it would turn over a few times then bind, loosen back up move around tighten again same problem. Was not machined right, total junk. Paid real money for a 98 Dakota mini and it works flawlessly. Tried to save money and it cost me more hmmm how many times did dad tell me buy good once!
Wow, I totally need to take a 1/4 inch of the input shaft