[WANTED] Need new rod pin bushings (small end)

[mayhem]

Need a set of 8 new pin bushings for a set of Manley rods. Ideally they would be part #42047-8 but Manley isn't producing these at this time and the rods are holding up the folks at the machine shop. Bushings are 1.154 od (but could be bigger & turned down), 1.031 id (but could be smaller & bored out), 1.250 wide. Engine shop guy said he spent an hour on the internet looking without luck. Where to look? Any help would be greatly apperciated. Thanks!

 

[Oldmanmopar]

The problem is aluminum/bronze material is hard to find right now. So that is why some bushings are out of stock.

 

[mayhem]

The problem is aluminum/bronze material is hard to find right now. So that is why some bushings are out of stock.

Thanks for the response. Any idea where I might find some of these?