What is the correct oil pickup for the 187 big block pan? Thank you drive through.
Thank you drive through.
Baffled pan or not?
Melling 63-S4 is for the non-baffled pan
I might be able to find the Melling # for the baffled, but here's the MP:
Mopar Performance Oil Pickup and Screen Assemblies P5007848
I have same pan/same problem.
What pickup did you use?
That's the one I bought. Pan does not lay flat on pan rails of block. I end up with 1/4-3/8" space between.
Did you have to make any alterations to 187 pan?
There is a few comments on summit about it being too long so they cut 1/2 to 3/4 inch off of the threaded end. I know Chrysler listed a low deck and raised deck pick ups as different numbers. Kim
I thought Mancini had the correct pickup tubes to work in this application, but I'll have to go dig thru some papers and pix for a confirmation....
Sounds like the one from Summit should be for a 6qt. pan.
A while back I drilled and tapped for a 1/2 inch oil pickup. And have the 187 pan. Is there a 1/2 pickup available?
My SolutionHaven't used it yet.
What is the red wrench?Gosh yall, this is really much ado about nothing. The red wrench will come right out and make easy work of however it needs to be bent and do a nice job.