Ok Im Back!!!

[farmer260]

I have the pushrod holes in my heads all enlarged but I want to make sure the rods are not hitting and a friend told me to use layout die or machinist die on the rods then turn the engine over by hand and the die will rub off if they are hitting. here is the problem! I cant find any die in Fredericton and im not sure what i should buy so its hard to find on the internet! is there something else i could use? Any ideas?

 

[Coyote Jack]

Good to see you back farmer. You could try some of that marker that rubs off. Not the permanent kind.

Jack

 

[qwk dust]

Just a quick question away... You pick the quickest to you. This is how I found what I needed for the port job on my heads. good luck

http://cgi.ebay.com/Dykem-Steel-Blu...39:1|66:2|65:12|240:1318&_trksid=p3286.c0.m14

http://cgi.ebay.com/Dykem-Steel-Blu...39:1|66:2|65:12|240:1318&_trksid=p3286.c0.m14

http://cgi.ebay.com/8-FL-Oz-ITW-Dyk...1760635QQcmdZViewItem?_trksid=p3286.m20.l1116

 

[BJR Racing]

Do you have a art supply shop around you? If so go and ask for window marker, the stuff that they use for store windows during the holidays, it comes off easy too. Just a thought.

 

[farmer260]

window marker sounds like the winner!!! it shouldnt flake off into the engine though will it?

 

[farmer260]

I thought of markers but the rods are black so i dont think they will work

 

[BJR Racing]

window marker sounds like the winner!!! it shouldnt flake off into the engine though will it?

The stuff is like the geddix window or ET dial in marker. And you can get it in different colors than white or yellow.