straightlinespeed
Sometimes I pretend to be normal
2 part question here. So Im rewiring my car and I have multiple things (electric fan relays, headlight relays, etc...) wired under the hood, under the battery tray. The 3 relays all need to run to a 12v power source. I didnt want to run them all to the starter relay stud, just because I will already have 2 large wires on that. Would it be ok to install a junction stud like below somewhere under the hood? Then if so how would I protect that stud so that nothing touches it? If that is not a good idea, how should I terminate all these wires?
View attachment stud.jpg
2nd part of the question is that the relays all have fuses installed on the 12ga. wire that will be terminated at the 12v source. Im assuming this is protection enough for the circuit and I dont have to install a fusable link wire.
View attachment stud.jpg
2nd part of the question is that the relays all have fuses installed on the 12ga. wire that will be terminated at the 12v source. Im assuming this is protection enough for the circuit and I dont have to install a fusable link wire.