MOPAROFFICIAL
Oogliboogli
That what y'all need to get'r done?
Bitches be raining when I show up.
Bitches be raining when I show up.
Single plane vs dual plane intake
- Thread starter Dan s
- Start date
-
MOPAROFFICIAL
Oogliboogli
Mainly all of these intakes need work cause they hinder any decent set of cylinder heads. A port that flows 278 only flowed 246 cfm after bolting a ootb victor 340 i bought off here in 2010 onto it.
Gasket match, semi deep runner porting, narrowing the dividers at plenum and bull nosing under flange and it flowed 265 cfm.
Nothing outrageous, but well needed.
Gasket match, semi deep runner porting, narrowing the dividers at plenum and bull nosing under flange and it flowed 265 cfm.
Nothing outrageous, but well needed.
I understand everything you just said except "bull nosing under flange". Can you explain further?
Cley
Cley
MOPAROFFICIAL
Oogliboogli
Some grind from the flange straight to the top of the runners, not the best way.
Get a victor 340 intake in front you and re read
Picture time.... if only one was available....
-
